›

DROP OUTS?

thesavagethesavage
edited October 2012 in Support
Is there and way or trick to drop out the sound of a whole song for a beat or two, ....then back in on beat.

Basically a hip hop drop out?

Comments

  • kadathkadath
    edited 6:27PM
    Automate the master track's volume so that it immediately drops out where you want it to.
  • thesavagethesavage
    edited 6:27PM
    man....thank you kadath. You think you could break that down for me in steps?
  • thesavagethesavage
    edited 6:27PM
    It think it got it, but what if you want drop out all the music tracks but just keep the vocal track?

    Like drop out one bar on the punchline of a verse?
  • kadathkadath
    edited 6:27PM
    You'd have to automate a volume drop for every track except the vocal track.

    This sort of thing gets easier if you render out your instrumental tracksand vocal track to WAVS and then load them into a multitrack recorder where you just need to cut the volume on a single track containing your instrumental, while the separate vocal track continues to play.
  • dubhausdiscodubhausdisco
    edited 6:27PM
    The easiest way (within bm2) would be to simply trim up your sequences where you want the break. For any long samples that may continue to play, just switch them to "hold" and trim the notes accordingly.
    Make sense?
  • thesavagethesavage
    edited 6:27PM
    Thanks guys! Yeah i use Logic but was trying to figure out a easy way in BM.
    haven't had time to try it yet seems a little tricky in BM at this point.
Sign In or Register to comment.